Дюсон. Ортопедические кроватные основания и мебельная фурнитура ООО "Дюсон"
Flexible bed bases
and furniture fittings.
Production and sale.
 x 

+7 (8332) 22-88-44

OOO Duson

65, Svoboda st., Kirov

ул. Свободы, д. 65 Киров, RU +7 (8332) 22-88-44

The basis of the bed-type is a flexible Energoflex 2 UT

Double flexible bed base — a couch with adjustable height of lumbar, lower back and head zones with the help of the control panel and two electric motors.
Энергофлекс 2 главный вид
Энергофлекс 2 вид 2
Энергофлекс 2 вид 3
Энергофлекс 2 вид 4

It is installed in a bed or used as an independent structure for the organization of a berth. There is a symmetrical raising of the foot zone and the head area.

A base frame is made of a flat-faced birch blocks, connected with each other by corner units UUP 05.60.24 with external radii of roundings of 56 mm. The bars of the lifting parts are connected with each other by the screw confirmates 7x50 mm.

In the product, latoflexes with a width of 38 mm are installed on the lathe holders of the LDT 2.38-3 with three degrees of freedom.

The product can be completed with cursors and additional latoflexes for individual adjustment of the rigidity of the deflection of the sleeper.

The electric motors can work as synchronous with special Bluetooth module as asynchronous.

Synchronization can be turn off/on by control desk.

In case of power outage bed frame can be emergency lower.

The base height of the flexible bed base (up to the upper plane of the latot holder) is 245 mm. The required height is agreed with the customer.

The product in terms of its parameters and strength characteristics is not inferior to orthopedic grilles made from an all-welded profile metal tube.

Designed for use with latex or mattresses of similar thickness up to 120 mm.

Technical parameters:
Cross section of the outer frame 60 х 24 mm
Cross section of the inner frame 50 х 21 mm
Number of bed slats 26 pieces
Cross section of bed slats 37 х 8 mm
Type of bed slat holder 3 degree of mobility
Type of transformation Electric drive
Presence of regulators of rigidity Yes, 12 pieces
Presence of mattress holder Yes, 2 pieces
Supports Yes, 165 мм, 4 pieces
Технические характеристики
Сечение внешнего каркаса основания 60 х 24 мм
Сечение внутреннего каркаса 50 х 21 мм
Количество ламелей 26 шт
Сечение ламелей 37 х 8 мм
Тип латодержателя Три степени свободы
Тип трансформации Электропривод
Наличие регуляторов жесткости Есть, 12 шт
Наличие матрасодержателя Есть, 1 шт
Опоры Есть, 165 мм, 4 шт
RUB